Lincoln Nautilus: Exterior Lighting / Exterior Lamps

Switching the Turn Signal Lamps On and Off

Lincoln Nautilus. Exterior Lamps

Lincoln Nautilus. Exterior Lamps Push the lever up or down to switch the turn signal lamps on.

Set the lever to the middle position to switch the turn signal lamps off.

Note: Tap the lever up or down to make the turn signal lamps flash three times.

Switching the Daytime Running Lamps On and Off - Vehicles With: Configurable Daytime Running Lamps

WARNING: The daytime running lamps system does not activate the rear lamps and may not provide adequate lighting during low visibility driving conditions. Make sure you switch the headlamps on, as appropriate, during all low visibility conditions. Failure to do so may result in a crash.

  1. Using the instrument cluster controls on the steering wheel, select Settings.
  2. Select Vehicle.
  3. Select Lighting.
  4. Switch Daytime Running Lights on or off.

The daytime running lamps turn on when all of the following occur:

Note: Other lighting control positions do not turn on the daytime running lamps.

Switching the Daytime Running Lamps On and Off - Vehicles With: Daytime Running Lamps (DRL)

WARNING: The daytime running lamps system does not activate the rear lamps and may not provide adequate lighting during low visibility driving conditions. Make sure you switch the headlamps on, as appropriate, during all low visibility conditions. Failure to do so may result in a crash.

Daytime running lamps are always on unless you switch on the headlamps or your vehicle is in park (P).

Switching the Front Fog Lamps On and Off (If Equipped)

The front fog lamp button is on the lighting control.

Lincoln Nautilus. Exterior Lamps Press the button to switch the front fog lamps on or off.

Note: Only switch the front fog lamps on during reduced visibility.

Note: The brightness of the daytime running lamps may decrease when the front fog lamps are switched on.

Note: When the lighting control is in the autolamps position, you cannot switch the fog lamps on unless the headlamps are on.

Switching Welcome Lighting On and Off

Lincoln Embrace: Welcome Lighting

Welcome lighting slowly turns on the exterior lamps when you approach your vehicle with an authenticated device or unlock the doors.

  1. Using the instrument cluster controls on the steering wheel, select Settings.
  2. Select Vehicle.
  3. Select Lighting.
  4. Switch Welcome Lighting on or off.

Exterior Lamp Indicators

Front Fog Lamp

Lincoln Nautilus. Exterior Lamps It illuminates when you switch the front fog lamps on.

Turn Signal Lamp

Lincoln Nautilus. Exterior Lamps It flashes when you switch the turn signal lamps on.

Note: An increase in the rate of flashing warns of a failed turn signal lamp bulb.

Exterior Lamp Audible Warning

Exterior Lamps On

Sounds when you open the driver door and the exterior lamps are on.

Autolamps
What Are Autolamps WARNING: The system does not relieve you of your responsibility to drive with due care and attention. You may need to override the system if it does not turn the headlamps on in ...

Automatic High Beam Control
How Does Automatic High Beam Control Work Automatic high beam control turns the high beams on if it is dark enough and no other traffic is present. If it detects an approaching vehicle’s headlamp ...

Other information:

Hyundai Creta GS 2014-2025 Service Manual: Repair procedures
Service Adjustment Procedure Steering Wheel Play Inspection 1. Turn the steering wheel so that the front wheels are placed in the straight ahead position. 2. Measure the distance that the steering wheel is turned ...

Hyundai Creta GS 2014-2025 Service Manual: Components and components location
Components Location 1. PCV valve 2. Canister 3. Fuel tank air filter 4. Purge control solenoid valve (PCSV) 5. Catalytic converter (WCC/UCC) 1. PCV valve 2. Canister ...

© 2017-2025 www.hcrmangs.com