Hyundai Creta: Air Conditioning System / Compressor oil: Repair procedures

Oil Specification
1.
The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed.
2.
Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the compressor model.
Oil Handling
1.
The oil should be free from moisture, dust, metal powder, etc.
2.
Do not mix with other types of oil.
3.
The water content in the oil increases when exposed to air. After use, seal oil from air immediately. (HFC-134a Compressor Oil absorbs moisture very easily.)
4.
The compressor oil must be stored in steel containers, not in plastic containers.
Compressor Oil Check
The oil used to lubricate the compressor circulates with the refrigerant.
Whenever replacing any component of the system or in case of a large amount of gas leakage, add oil to maintain the original amount of oil.
Oil total volume in system
PAG OIL : 110 ± 10 cc (3.88 ± 0.35 oz.)
Oil Return Operation
There is a close affinity between the oil and refrigerant.
During normal operation, some of the oil recirculates with the refrigerant in the system. When checking the amount of oil in the system, or replacing any component of the system, the compressor must run in advance for oil return operation. The procedure is as follows:
1.
Open all the doors and engine hood.
2.
Start the engine turn the air conditioning switch to "ON" and set the blower motor control knob at its highest position.
3.
Run the compressor for more than 20 minutes between 800 and 1,000 rpm in order to operate the system.
4.
Stop the engine.
Components and components location
Component Location Index [Engine Room] 1. Ambient temperature Sensor 2. Condenser 3. Compressor 4. Discharge Hose 5. Service Port (High Pressu ...

Refrigerant Line
Components and components location Components Location 1. Refrigerant Line Assembly Repair procedures Replacement 1. ...

Other information:

Hyundai Creta GS 2014-2026 Service Manual: General information
Identification Number Identification Number Description Vehicle Identification Number 1. World Manufacturer Identifier (WMI) – MAL : Passenger vehicle or MPV(Multipurpose Passenger vehicle)/SUV(Sports Utility v ...

Lincoln Nautilus 2018-2026 Owners Manual: Adjusting the Headlamps
Vertical Aim Adjustment The headlamps on your vehicle are properly aimed at the assembly plant. If your vehicle has been involved in a crash, have the aim of the headlamp beam checked by an authorized dealer. Headlamp Aiming Target 8 ft (2.4 m). Center height of lamp to ground. 25 ft (7.6 m ...

© 2017-2026 www.hcrmangs.com