Hyundai Creta: Cruise control / Cruise Control Operation

1. CRUISE indicator
2. SET indicator

The Cruise Control system allows you to drive at speeds above 40 km/h (25 mph) without depressing the accelerator pedal.

WARNING

Take the following precautions:

• If the Cruise Control is left on, (CRUISE indicator light in the instrument cluster illuminated) the Cruise Control can be activated unintentionally. Keep the Cruise Control system off ( /CRUISE indicator light OFF) when the Cruise Control is not in use, to avoid inadvertently setting a speed.
• Use the Cruise Control system only when traveling on open highways in good weather.
• Do not use the Cruise Control when it may not be safe to keep the vehicle at a constant speed:

- Driving in heavy or varying speed traffic.
- On slippery (rainy, icy or snow covered) roads.
- Hilly or winding roads.
- Very windy areas.

Cruise control switch

CRUISE: Turns cruise control system on.

CANCEL: Cancels cruise control operation.

RES+: Resumes or increases cruise control speed.

SET-: Sets or decreases cruise control speed.

To set Cruise Control speed

1. Push the CRUISE button on the steering wheel to turn the system on. The /CRUISE indicator will illuminate.

2. Accelerate to the desired speed, which must be more than 40 km/h (25 mph).

Information

For manual transaxle vehicles, you should depress the brake pedal at least once to set the cruise control after starting the engine.

3. Push the lever (1) down (SET-), and release it. The SET indicator light will illuminate.

4. Release the accelerator pedal.

Information

The vehicle may slow down or speed up slightly while going uphill or downhill.

To increase Cruise Control speed

• Push the lever (1) up (RES+) and
  
  hold it, while monitoring the SET speed on the instrument cluster. Release the lever when the desired speed is shown and the vehicle will accelerate to that speed.
• Push the lever (1) up (RES+) and release it immediately. The cruising speed will increase 2.0 km/h (1.2 mph) each time the lever is operated in this manner.

To decrease Cruise Control speed

• Push the lever (1) down (SET-) and hold it. Your vehicle will gradually slow down. Release the lever at the speed you want to maintain.
• Push the lever (1) down (SET-) and release it immediately. The cruising speed will decrease 2.0 km/h (1.2 mph) each time the lever is operated in this manner.
• Lightly tap the brake pedal. When the vehicle attains the desired speed, push the lever (1) down (SET-).

To temporarily accelerate with the Cruise Control ON

Depress the accelerator pedal. When you take your foot off the accelerator, the vehicle will return to the previously set speed.

If you push the lever down (SET-) at the increased speed, the Cruise Control will maintain the increased speed.

Cruise Control will be canceled when:

• Depressing the brake pedal.
• Depressing the clutch pedal. (for manual transaxle vehicle)
• Pressing the CANCEL button located on the steering wheel.
• Moving the shift lever into N (Neutral). (for automatic transaxle vehicle)
• Decreasing the vehicle speed lower than the memory speed by 15 km/h (9 mph).
• Decreasing the vehicle speed to less than approximately 40 km/h (25 mph).
• The ESC (Electronic Stability Control) is operating.
• Downshifting to the 2nd gear in Sports Mode.

Information

Each of the above actions will cancel Cruise Control operation (the SET indicator light in the instrument cluster will go off), but only pressing the CRUISE button will turn the system off. If you wish to resume Cruise Control operation, push the lever up (RES+) located on your steering wheel. You will return to your previously preset speed, unless the system was turned off using the CRUISE button.

To resume preset Cruising speed

Push the lever (1) up (RES+). If the vehicle speed is over 40 km/h (25 mph), the vehicle will resume the preset speed.

To turn Cruise Control off

• Press the CRUISE button (the / CRUISE light will go off).
• Turn the engine OFF.