Hyundai Creta: Fuel Delivery System / Fuel Line: Repair procedures

Removal

1.	Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")

2.	Turn the ignition switch OFF, and then remove battery (-) terminal.

3.	Remove the fuel tank. (Refter to Fuel Delivery System - "Fuel Tank")

4.	Remove the installation nut (B), and then disconnect the fuel feed tude (A).

5.	Disconnect the vapor hose (A) which is connected from the PCSV.

6.	Lift the vehicle.

7.	Remove the fuel & brake line protect (A).

Remove the low pressure fuel tube mounting nut (A).

Fuel tube clamp mounting nut :

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

9.	Remove the fuel line (A) from the vehicle,

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

1.	Install in the reverse order of removal.

Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Disconnect the electric pump wiring co ...

Removal 1. Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A). 2. Lift the vehicle. ...

Hyundai Creta GS 2014-2019 Service Manual: Components and components location
Components Location Supplemental Restraint System Control Module (SRSCM) 1. Supplemental Restraint System Control Module (SRSCM) Driver Airbag (DAB) / Passenger Airbag (PAB) 1. Driver Airbag (DAB) ...

Hyundai Creta GS 2014-2019 Service Manual: Fuel Pump: Repair procedures
Inspection [Fuel pump] 1. Turn ignition switch OFF and disconnect the negative (-) battery terminal. 2. Remove the fuel pump assembly. 3. Check motor operation by fuel pump connector (A) conn ...