Hyundai Creta: Hood / Hood Latch Release Handle

Hyundai Creta GS 2014-2025 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle

Components and components location

Component Location

1. Hood latch release handle

Repair procedures

Replacement

Using a screwdriver or remover, remove the hood release handle (A).

•	Use a 6mm hex bit to press the center until the handle easily pulls off the post.

To install, reverse the removal procedure.

•	Make sure the hood latch cable is connected properly.

•	Make sure the hood locks/unlocks and opens / closes properly.

Hood Weatherstrip: Repair procedures

Replacement 1. Remove the hood weatherstrip (A). • ...

Hood Latch

Components and components location Component Location 1. Hood latch assembly Repair procedures Replacement 1. After l ...

Other information:

Hyundai Creta GS 2014-2025 Service Manual: 26 Brake Control Solenoid Valve (26/B_VFS)
Description and operation Description • 26 brake control solenoid valve (26/B_VFS) is attached to the valve body. • This variable force solenoid valve indirectly controls the hydraulic pressure inside the 26Brake. ...

Hyundai Creta GS 2014-2025 Service Manual: Accelerator Position Sensor (APS)
Description and operation Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensor ...