Replacement |
1. |
Remove the condenser.
|
2. |
Remove the cap (B) on the bottom of the condenser with a L wrench (A).
|
3. |
Remove the receiver-drier (A) from condenser using a long nose plier.
Check for crumbled receiver-drier and clogged bottom cap filter.
|
4. |
Apply air conditioning compressor oil along the O-rings and threads
of the new bottom cap.
|
5. |
Insert a new receiver-drier into the receiver drier tank. The receiver-drier
must be sealed in vacuum before it is exposed to air for use.
|
6. |
Install a new bottom cap to the condenser.
|
Hyundai Creta GS 2014-2024 Service Manual: Oil Pressure Switch: Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
2.
Remove the engine room under cover.
(Refer to Engine And Transaxle Assmbly - "Engine Room Under Cover" )
3.
Drain the e ...
Hyundai Creta GS 2014-2024 Service Manual: Power Seat Control Switch
Schematic diagrams
Circuit Diagram
Repair procedures
Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat switch. ...