Hyundai Creta: Steering wheel / Repair procedures

Removal
1.
Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
2.
Turn the steering wheel so that the front wheels are placed in the straight ahead position.
3.
Loosen the torx bolts which are located on the both side of the steering wheel.

4.
Remove the DAB module then disconnect the clock spring connector (A).

5.
Loosen the steering wheel lock bolt and then separate the steering wheel.
Tightening torque :
39.2 ~ 49.0 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)

  
Do not reuse the bolt.
6.
Install in the reverse order of removal.
Disassembly
1.
Loosen the screw and then remove the lower cover.

2.
Disconnect the remote control connector.

3.
Loosen the screw and then remove the remote contorl switch.

4.
Reassembly in the reverse order of disassembly.
Components and components location
Components 1. Lower cover 2. wiring 3. steering wheel 4. Remote control RH 5. Remote control LH 6. Drive air bag ...

Electric Power Steering
...

Other information:

Hyundai Creta GS 2014-2025 Service Manual: Engine Room Under Cover
Components and components location Components 1. Engine room side cover Repair procedures Removal and Installation Engine room under cover front pannel 1. Remove the engine room under cover (A). ...

Hyundai Creta GS 2014-2025 Service Manual: Steering Angle Sensor: Description and operation
Description Steering angle sensor The Steering Angle Sensor (SAS) is installed in EPS (Electric Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning direction and speed of the steering wheel. The HECU uses t ...

© 2017-2025 www.hcrmangs.com