Hyundai Creta: Blower / Blower Motor: Repair procedures

Inspection

1.	Connect the battery voltage and check the blower motor rotation.

2.	If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.

3.	Replace the blower motor if it is proved that there is a problem with it.

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws.

3.	Install in the reverse order of removal.

Components and components location Component Location 1. Blower unit assembly Components 1. Inlet Seal 2. Intake duct case ...

Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor ...

Hyundai Creta GS 2014-2019 Service Manual: Door Scuff Trim
Components and components location Component Location 1. Front door scuff trim 2. Rear door scuff trim Repair procedures Replacement • ...

Hyundai Creta GS 2014-2019 Service Manual: Floor Console Assembly
Components and components location Component Location 1. Floor console assembly Repair procedures Replacement [MT] • Put on glove ...