| Inspection |
| 1. |
Measure the resistance between the terminals.
|
| 2. |
The measured resistance is not within specification, the blower resistor
must be replaced. (After removing the resistor)
|
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
|
| 3. |
Disconnect the connector (A) and then remove the blower resistor (B)
after loosening the mounting screws.
|
| 4. |
Install in the reverse order of removal.
|
Blower Motor: Repair procedures
Power Mosfet (DATC)Hyundai Creta GS 2014-2019 Owners Manual: Normal maintenance schedule (Except Mexico) – Gasoline engine
I : Inspect and if necessary, adjust, correct, clean or replace.
R : Replace or change.
*1 : Adjust alternator and power steering (and water pump drive belt) and air
conditioner drive belt (if equipped).
Inspect and if necessary correct or replace.
*2 : Check the engine oil level and lea ...
Hyundai Creta GS 2014-2019 Service Manual: Catalytic Converter: Description and operation
Description
The catalytic converter of the gasoline engine is a three way catalyst. It oxidizes
carbon monoxide and hydrocarbons (HC), and separates oxygen from the oxides
of nitrogen (NOx).
...