Hyundai Creta: Clutch System / Clutch Pedal

Components and components location

Components

1. Clutch pedal assembly
2. Clutch pedal arm
3. Ignition lock & clutch switch
4. Washer
5. Snap pin
6. Master cylinder
7. Reservoir hose

Repair procedures

Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower pannel.
(Refer to Body - "Crash Pad")
3.
Disconnect the ignition lock & clutch switch connector (A).

4.
Disconnect the push rod from the clutch pedal by removing the snap pin (A) and washer (B).
5.
Remove the clutch pedal mounting nuts (C-4ea).
Tightening torque :
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 Ib-ft)

6.
Remove the clutch pedal assembly from the vehicle.
Installation
1.
Install in the reverse order of removal.
Clutch Switch
Specifications Specifications Item Specifications Working voltage DC 12V Operating force Initial posi ...

Clutch Tube
Components and components location Components [M6CF1] 1. Clutch pedal assembly 2. Clutch pedal arm 3. Ignition lock & clutch switch 4. Washe ...

Other information:

Hyundai Creta GS 2014-2024 Service Manual: Repair procedures
Inspection Check it by the procedure below to see if the function of the ECM is normal. 1. Turn the ignition key to the "ON" position. 2. Cover the forward facing sensor. 3. Head a light to the re ...

Hyundai Creta GS 2014-2024 Owners Manual: Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance. In most cases, you will not need to have your wheels aligned again. However, if you notice unusual tire wear or your vehicle pulling one way or ...

© 2017-2024 www.hcrmangs.com