Hyundai Creta: Air Conditioning System / Compressor oil: Repair procedures

Hyundai Creta GS 2014-2024 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Compressor oil: Repair procedures

Oil Specification

1.	The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed.

2.	Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the compressor model.

Oil Handling

1.	The oil should be free from moisture, dust, metal powder, etc.

2.	Do not mix with other types of oil.

3.	The water content in the oil increases when exposed to air. After use, seal oil from air immediately. (HFC-134a Compressor Oil absorbs moisture very easily.)

4.	The compressor oil must be stored in steel containers, not in plastic containers.

Compressor Oil Check

The oil used to lubricate the compressor circulates with the refrigerant.

Whenever replacing any component of the system or in case of a large amount of gas leakage, add oil to maintain the original amount of oil.

Oil total volume in system

PAG OIL : 110 ± 10 cc (3.88 ± 0.35 oz.)

Oil Return Operation

There is a close affinity between the oil and refrigerant.

During normal operation, some of the oil recirculates with the refrigerant in the system. When checking the amount of oil in the system, or replacing any component of the system, the compressor must run in advance for oil return operation. The procedure is as follows:

1.	Open all the doors and engine hood.

2.	Start the engine turn the air conditioning switch to "ON" and set the blower motor control knob at its highest position.

3.	Run the compressor for more than 20 minutes between 800 and 1,000 rpm in order to operate the system.

4.	Stop the engine.

Components and components location

Component Location Index [Engine Room] 1. Ambient temperature Sensor 2. Condenser 3. Compressor 4. Discharge Hose 5. Service Port (High Pressu ...

Refrigerant Line

Components and components location Components Location 1. Refrigerant Line Assembly Repair procedures Replacement 1. ...

Other information:

Hyundai Creta GS 2014-2024 Service Manual: Power Door Lock Actuators: Repair procedures
Inspection Front Door Lock Module Inspection 1. Remove the front door trim. (Refer to Body - "Front Door Trim") 2. Remove the front door module. (Refer to Body - "Front Door Module") ...

Hyundai Creta GS 2014-2024 Service Manual: Components and components location
Component Location 1. Smart key unit 2. Interior antenna 1 3. Door outside handle 4. Start Stop Button (SSB) 5. Electronic steering column lock (ESCL) 6. FOB key ...