Hyundai Creta: Manual Transaxle Control System / Control Shaft Assembly

Hyundai Creta GS 2014-2025 Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Shaft Assembly

Description and operation

Description
Control shaft assembly is mounted on the top of the manual transmission, and select & shift cable are equipped.
Control shaft assembly is operated by shifting the shift lever.

Repair procedures

Removal
1.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - " Air Cleaner)
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Remove the ECM.
(Refer to Engine Control System - "ECM")
4.
Remove the snap pin (A-2ea) and then removing the select cable (B) and shift cable (C).
5.
Remove the control shaft assembly (A) after loosen the bolts.
Tightening torque :
19.6 ~ 26.5 N.m (2.0 ~ 2.7 kgf.m,14.5 ~ 19.5 lb-ft)

Installation
1.
Install in the reverse order of removal.
  
•
When installing, set control shaft lever to neutral position.
•
When installing, apply the sealant as shown in the illustration.
Specified sealant : MS 721-40 or MS721-38

2.
After installing, check to be sure that this part operates as designed at each range of transaxle side corresponding to each position of shift lever.
Control Cable
Components and components location Components 1. Shift lever knob & boots 2. Shift lever assembly 3. Shift cable 4. Select cable 5. Retainer 6. 4th ...

Automatic Transaxle System
...

Other information:

Hyundai Creta GS 2014-2025 Service Manual: Timing Chain Cover
Components and components location Components 1. Timing chain cover Repair procedures Removal    • Use fender covers to avoid damaging painte ...

Hyundai Creta GS 2014-2025 Service Manual: Description and operation
Description Communication Network Diagram Abbreviation Explanation 4WD_ECU 4WD Control Unit A/CON Aircon Control ACU Airbag Control Unit B_CAN ...

© 2017-2025 www.hcrmangs.com