Hyundai Creta: Fuel Delivery System / Delivery Pipe: Repair procedures
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
terminal.
|
| 2. |
Release the residual pressure in fuel line.
(Refer the fuel Delivery system - Repair Procedures - "Release Residual
Pressure in Fuel Line")
| •
|
When removing the fuel pump fuse, a Diagnostic Trouble
Code (DTC) may occur. Delete the code with the GDS after
completion of "Release Residual Pressure in Fuel Lin"
work.
|
|
|
| 3. |
Disconnect the injector connector (A).
|
| 4. |
Remove the wiring harness bracket mounting bolt (B).
|
| 5. |
Remove the mounting nut, and then disconnect the fuel feed tube (C).
|
| 6. |
Remove the mounting bolt, and then remove the delivery pipe & injector
assembly from the engine.
|
| 7. |
Remove the fixing clip (A), and then separate the injector from the
delivery pipe.
|
| • |
Install the component with the specified torques.
|
| • |
Note that internal damage may occur when the component is dropped.
In this case, use it after inspecting
|
|
| • |
Apply the engine oil to the injector O-ring.
|
|
| • |
Inspect the injector O-ring when installing.
|
|
| 1. |
Install in the reverse order of removal.
|
Delivery pipe mounting bolt :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Delivery pipe mounting nut (↔ Fuel feed tube) :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
|
|
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery
terminal.
2.
Disconnect the accelerator position senso ...
Accelerator Pedal: Repair procedures
Clutch System