Hyundai Creta: Ignition System / Description and operation

Ignition timing is controlled by the electronic control ignition timing system.

The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module).

The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM.

The ignition coil is activated, and timing is controlled.

Ignition System

...

Repair procedures

On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.    ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Description and operation
Description Burglar Alarm State [B/A State] B/A State Description DISARM 1) This is the state when "ARM" mode is off. 2) If all doors or hoo ...

Hyundai Creta GS 2014-2019 Owners Manual: Tilt steering
WARNING Never adjust the steering wheel while driving. You may lose steering control and cause severe personal injury, death or accidents. Pull down the lock-release lever (1) on the steering wheel column and adjust the steering wheel angle (2). Move the steering wheel, so it points ...