Hyundai Creta: Charging System / Description and operation
The charging system included a battery, an alternator with a built-in regulator,
and the charging indicator light and wire.
The Alternator has eight built-in diodes, each rectifying AC current to DC current.
Therefore, DC current appears at alternator "B" terminal.
In addition, the charging voltage of this alternator is regulated by the battery
voltage detection system.
The alternator is regulated by the battery voltage detection system. The main
components of the alternator are the rotor, stator, rectifier, capacitor brushes,
bearings and V-ribbed belt pulley. The brush holder contains a built-in electronic
voltage regulator.

1. Brush
2. Drive belt pulley
(OAD : Overrunning Alternator Decoupler)
3. Rotor
4. Stator
5. Rectifier
|
Alternator Management
System |
Alternator management system controls the charging voltage set point in order
to improve fuel economy, manage alternator load under various operating conditions,
keep the battery charged, and protect the battery from over-charging. ECM controls
generating voltage by duty cycle (charging control, discharging control, normal
control) based on the battery conditions and vehicle operating conditions.
The system conducts discharging control when accelerating a vehicle. Vehicle
reduces an alternator load and consumes an electric power form a battery.
The system conducts charging control when decelerating a vehicle. Vehicle increases
an alternator load and charges a battery.
On-vehicle Inpection
•
First of all, check for DTCs. If a DTC is present, perform tro ...
Other information:
Hyundai Creta GS 2014-2025 Service Manual: Repair procedures
Repair procedures
ABS System Bleeding
This procedure should be followed to ensure adequate bleeding of air and filling
of the ESC unit, brake lines and master cylinder with brake fluid.
1.
Remove the reservoir cap and fill the brake reservoir with brake flu ...
Hyundai Creta GS 2014-2025 Service Manual: Automatic Transaxle
Components and components location
Components Location (1)
1. Automatic transaxle assembly
2. ATF cooler tube
3. Ground line
4. Shift cable mounting bracket
5. Shift cable
6. Inhibitor switch & manual control lever
7. Clamp
8. ATF cooler ho ...