Hyundai Creta: Starting System / Description and operation

Description
The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable.
When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.
The solenoid plunger and clutch shift lever are activated, and the clutch pinion engages the ring gear.
The contacts close and the starter motor cranks.
In order to prevent damage caused by excessive rotation of the starter armature when the engine starts, the clutch pinion gear overruns.

1. Magnet switch assembly
2. Brush holder assembly
3. Armature assembly
4. Over runing clutch assembly

Starting System
...

Troubleshooting
Troubleshooting    • The battery must be in good condition and fully charged for ...

Other information:

Hyundai Creta GS 2014-2024 Service Manual: Rear Door Belt Inside Weatherstrip: Repair procedures
Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the rear door belt inside weatherstrip (A). 3. To install, reverse the removal procedure. ...

Hyundai Creta GS 2014-2024 Service Manual: Audio Unit
Components and components location Components [Radio/CD/MP3] Connector Pin Information No Connector A Connector B 1 Rear left speaker (+) - 2 Front left spea ...

© 2017-2024 www.hcrmangs.com