Hyundai Creta: General Information / Description and operation

Hyundai Creta GS 2014-2019 Service Manual / Restraint / General Information / Description and operation

Warning Lamp Activation

Warning Lamp Behavior after Ignition On

As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp for a LED lamp check.

The lamp shall turn on for 6 seconds during the initialization phase and be turned off afterward.

To alert the driver, the warning lamp shall turn on for 6 seconds and off for one second then on continuously after the operating voltage is applied if any active fault exists.

1.	Active fault.

2.	Normal or historical fault only exist.

When turning the ignition switch ON during variant coding (EOL) mode, the airbag warning lamp is turned on and blinks at intervals of 1 second till the coding is completed.

If the variant coding is completed normally, the airbag warning lamp will turn on for 6 seconds, and then turned off. Otherwise the airbag warning lamp continuously blinks at intervals of 1 second.

(1)	In case the variant coding is normally completed

(2)	In case the variant coding is not completed

When there is active fault in airbag system or SRSCM internal fault, the variant coding (EOL) cannot be completed. In this case, perform the variant coding (EOL) procedure again after troubleshooting with the GDS.

SRSCM Independent Warning Lamp Activation

There are certain fault conditions in which the SRSCM cannot function and thus cannot control the operation of the standard warning lamp. In these cases, the standard warning lamp is directly activated by appropriate circuitry that operates independently of the SRSCM. These cases are:

1.	Loss of battery supply to the SRSCM : warning lamp turned on continuously.

2.	Loss of internal operating voltage : warning lamp turned on continuously.

3.	Loss of Microprocessor operation : warning lamp turned on continuously.

4.	SRSCM not connected : warning lamp turned on continuously.

General safety information and caution

Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in ...

Repair procedures

Component Replacement After Deployment • Before doing any SRS repairs, use the GD ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Heater Core: Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") 3. Remove the heater core cover (A) after loosening th ...

Hyundai Creta GS 2014-2019 Service Manual: Components and components location
Component Location 1. Smart key unit 2. Interior antenna 1 3. Door outside handle 4. Start Stop Button (SSB) 5. Electronic steering column lock (ESCL) 6. FOB key ...