Hyundai Creta: Air bag-supplemental restraint system(SRS) / Do not install a child restraint on the front passenger's seat.
■ Type A
■ Type B
Never place a rear-facing child restraint in the front passenger’s seat. If the air bag deploys, it would impact the rear-facing child restraint, causing serious or fatal injury.
In addition, do not place front-facing child restraints in the front passenger’s seat either. If the front passenger air bag inflates, it would cause serious or fatal injuries to the child.
WARNING
- NEVER use a rearward facing child restraint on a seat protected by an ACTIVE AIR BAG in front of it, DEATH or SERIOUS INJURY to the CHILD can occur.
- Never put a child restraint in the front passenger’s seat. If the front passenger air bag inflates, it would cause serious or fatal injuries.
- When children are seated in the
rear outboard seats of vehicle
equipped with curtain air bags,
be sure to install the child
restraint system as far away
from the door side as possible,
and securely lock the child
restraint system in position.
Inflation of curtain air bags could cause serious injury or death to an infant or child.
How does the air bag system
operate
Air bags are activated (able to
inflate if necessary) only when the
ignition switch is placed to the ON
or START position.
Air bags inflate instantly in the
event of serious frontal o ...
Air bag warning and indicator
Air bag warning light
The purpose of the air bag warning
light in your instrument panel is to
alert you of a potential problem with
your air bag - Supplemental Restraint
System (SRS).
When ...
Other information:
Hyundai Creta GS 2014-2023 Service Manual: Turn Signal Lamp: Repair procedures
Removal
Door Mirror Turn Signal Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mirror holder (A) from the outside mirror assembly.
...
Hyundai Creta GS 2014-2023 Service Manual: General information
General Service Information
Protection of the Vehicle
Always be sure to cover fenders, seats, and floor areas prior to beginning work.
The support rod must be inserted into the hole near the edge of the ...
