Hyundai Creta: Cylinder Block Assembly / Drive Plate: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Engine Mechanical System / Cylinder Block Assembly / Drive Plate: Repair procedures

Removal and Installation

1.	Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle")

Remove the adapter plate (A) and drive plate (B).

Tightening torque :

71.5 ~ 75.5 N.m (7.3 ~ 7.7 kgf.m, 52.8 ~ 55.6 lb-ft)

3.	Install in the reverse order of removal.

Components and components location

Components 1. Cylinder block 2. Ladder frame 3. Crankshaft 4. Crankshaft upper bearing 5. Crankshaft lower bearing 6. Thrust bearing 7. Main bearing ...

Flywheel: Repair procedures

Removal and installation 1. Remove the manual transaxle. (Refer to Manual Transaxle System - "Manual Transaxle") 2. Remov ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Repair procedures
Replacement • Put on gloves to protect your hands. • When ...

Hyundai Creta GS 2014-2019 Service Manual: Troubleshooting
Troubleshooting Symptom Possible cause Remedy Hard steering Improper front wheel alignment Excessive turning resistance of lower arm ball joint Low tire pressure No power assist Correct Replace ...