Hyundai Creta: Heater / Evaporator Core: Repair procedures
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
|
3. |
Remove the heater unit lower case (A) after loosening the mounting screws.
|
4. |
Pull out the evaporator core (A) from the heater unit.
|
5. |
Install in the reverse order of removal.
• |
If you're installing a new heater core, add refrigerant oil
(PAG OIL).
|
• |
Replace the O-rings with new ones at each fitting, and apply
a thin coat of refrigerant oil before installing them. Be sure
to use the right O-rings for R-134a to avoid leakage.
|
• |
Immediately after using the oil, replace the cap on the container,
and seal it to avoid moisture absorption.
|
• |
Do not spill the refrigerant oil on the vehicle; it may damage
the paint; if the refrigerant oil contacts the paint, wash it
off immediately.
|
• |
Apply sealant to the grommets.
|
• |
Make sure that there is no air leakage.
|
• |
Charge the system and test its performance.
|
• |
Do not interchange the inlet and outlet heater hoses and install
the hose clamps securely.
|
|
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater -"Hea ...
Components and components location
Components Location
1. Temperature control actuator
Description and operation
Description
The temperat ...
Other information:
Hyundai Creta GS 2014-2024 Owners Manual: Floor mat anchor(s)
ALWAYS use the Floor Mat Anchors
to attach the front floor mats to the
vehicle. The anchors on the front
floor carpet keep the floor mats from
sliding forward.
WARNING
The following must be observed
when installing ANY floor mat to
the vehicle.
Ensure that the floor mats are
s ...
Hyundai Creta GS 2014-2024 Owners Manual: Instrument panel fuse replacement
1. Turn the ignition switch and all
other switches off.
2. Open the fuse panel cover.
3. Pull the suspected fuse straight
out. Use the fuse puller provided in
the engine compartment fuse
panel.
4. Check the removed fuse; replace it
if it is blown.
5. Push in a new fuse of the same ...