Hyundai Creta: Body Side Molding / Fender Garnish: Repair procedures
| • |
Put on gloves to protect your hands.
|
|
| • |
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape
around the related parts, to prevent damage.
|
| • |
Take care not to scratch the body surface.
|
|
| 1. |
Loosen the fender garnish mounting screws.
|
| 2. |
Using a screwdriver or remover, remove the fender garnish (A).
|
| 3. |
To install, reverse the removal procedure.
| •
|
Replace any damaged clips.
|
|
|
Replacement
•
Put on gloves to protect your hands.
...
Replacement
•
Put on gloves to protect your hands.
...
Other information:
Hyundai Creta GS 2014-2019 Service Manual: Troubleshooting
Troubleshooting
Trouble Symptom
Cause of the symptom
Remedy
Excessive play in steering
Loose U-joint bolt
Retighten or replace as necessary
Loose yoke plug
Retighten
...
Hyundai Creta GS 2014-2019 Service Manual: Compressor
Description and operation
Description
The compressor is the power unit of the A/C system.
It is located on the side of engine block and driven by a V-belt of the engine.
The compressor changes low-pressure and low-temperature refrigerant gas into
high-pressure and high-te ...
A Pillar Garnish: Repair procedures
Quarter Garnish: Repair procedures