Hyundai Creta: Fuel Delivery System / Filler-Neck Assembly: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly: Repair procedures

Removal

1.	Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A).

2.	Lift the vehicle.

3.	Remove the rear-LH wheel, tire, end the inner wheel house.

4.	Disconnect the fuel filler hose (A), the vapor hose (B) and the leveling quick connector (C).

5.	Remove the filler-neck assembly from the vehicle after removing the bracket installation nut/ bolt (D).

Installation

1.	Install in the reverse order of removal.

Fuel Line: Repair procedures

Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") ...

Accelerator Pedal: Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal. 2. Disconnect the accelerator position senso ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Exhaust Manifold
Components and components location Components 1. Heat protector 2. Exhaust manifold 3. Gasket 4. Exhaust manifold stay Repair procedures Removal and Installation 1. Remove the engine cover. 2. ...

Hyundai Creta GS 2014-2019 Service Manual: Manifold Absolute Pressure Sensor (MAPS)
Description and operation Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal proportional to the pressure to the ECM. By using ...