Hyundai Creta: Cylinder Block Assembly / Flywheel: Repair procedures

Removal and installation
1.
Remove the manual transaxle.
(Refer to Manual Transaxle System - "Manual Transaxle")
2.
Remove the flywheel (A).
Tightening torque :
71.6 ~ 75.5 N.m (7.3 ~ 7.7 kgf.m, 52.8 ~ 55.6 lb-ft)

3.
Install in the reverse order of removal.
Drive Plate: Repair procedures
Removal and Installation 1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. ...

Rear Oil Seal: Repair procedures
Replacement 1. Remove the transaxle. • Automatic Transaxle (Refer to Automatic Transaxle System - "Automatic Transax ...

Other information:

Hyundai Creta GS 2014-2023 Service Manual: Knock Sensor (KS)
Description and operation Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. When knocking occurs, the vibration from the cylind ...

Hyundai Creta GS 2014-2023 Owners Manual: Normal maintenance schedule (Except Mexico) – Gasoline engine
I : Inspect and if necessary, adjust, correct, clean or replace. R : Replace or change. *1 : Adjust alternator and power steering (and water pump drive belt) and air conditioner drive belt (if equipped). Inspect and if necessary correct or replace. *2 : Check the engine oil level and lea ...

© 2017-2023 www.hcrmangs.com