Hyundai Creta: Windshield Wiper/Washer / Front Washer Motor: Repair procedures

Hyundai Creta GS 2014-2025 Service Manual / Body Electrical System / Windshield Wiper/Washer / Front Washer Motor: Repair procedures

Inspection
Front and Rear Washer Motor
1.
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
  
Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.
2.
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles.
3.
If they are abnormal, replace the washer motor.
No
Description
1
 Windshield washer (+)
2
 Ground
3
 Rear washer (+)

Removal
  
–
When servicing the washer pump, be careful not to damage the washer pump seal.
–
Do not operate the washer pump before filling the washer reservoir.
Failure to do so could result in premature pump failure.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front right wheel guard.
(Refer to Body - "Front Wheel Guard")
3.
Remove the washer reservoir after loosening the mounting bolts (A) and disconnect the washer motor connector.
4.
Remove the washer motor (A).
Installation
1.
Reassemble the washer reservoir.
  
•
Before installing the pump motor, check the filter for foreign material or contamination. if necessary, clean the filter into the pump motor.
2.
Connect the washer motor connector and washer hose.
3.
Reassemble the front bumper cover.
Front Wiper Motor
Components and components location Component Location 1. Cap 2. Nut 3. Wiper arm & blade 4. Rivet 5. Cowl top cover 6. Bolt 7. Wiper motor & ...

Rear Wiper/Washer
...

Other information:

Hyundai Creta GS 2014-2025 Service Manual: Rear Door Belt Inside Weatherstrip: Repair procedures
Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the rear door belt inside weatherstrip (A). 3. To install, reverse the removal procedure. ...

Hyundai Creta GS 2014-2025 Service Manual: Description and operation
Description Emissions Control System consists of three major systems. • The Crankcase Emission Control System prevents blow-by gas from releasing into the atmosphere. This system recycles gas back into the intake manifold (Closed Crankcase Ventilation ...

© 2017-2025 www.hcrmangs.com