Hyundai Creta: Fuel Delivery System / Fuel Line: Repair procedures

Removal
1.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
2.
Turn the ignition switch OFF, and then remove battery (-) terminal.
3.
Remove the fuel tank.
(Refter to Fuel Delivery System - "Fuel Tank")
4.
Remove the installation nut (B), and then disconnect the fuel feed tude (A).

5.
Disconnect the vapor hose (A) which is connected from the PCSV.

6.
Lift the vehicle.
7.
Remove the fuel & brake line protect (A).

8.
Remove the low pressure fuel tube mounting nut (A).
Fuel tube clamp mounting nut :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

9.
Remove the fuel line (A) from the vehicle,

Installation
  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
1.
Install in the reverse order of removal.
Fuel Pressure Regulator: Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Disconnect the electric pump wiring co ...

Filler-Neck Assembly: Repair procedures
Removal 1. Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A). 2. Lift the vehicle. ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Crankshaft
Components and components location Components 1. Crankshaft sprocket 2. Crankshaft thrust bearing 3. Crankshaft upper main bearing 4. Crankshaft 5. CKPS wheel 6. Crankshaft lower main bearing 7. Crankshaft main bearing cap Repair pr ...

Hyundai Creta GS 2014-2019 Owners Manual: Exterior care
Exterior general caution It is very important to follow the label directions when using any chemical cleaner or polish. Read all warning and caution statements that appear on the label. Finish maintenance Washing To help protect your vehicle’s finish from rust and deterioration, wash ...

© 2017-2026 www.hcrmangs.com