
The speedometer indicates the speed of the vehicle and is calibrated in kilometers per hour (km/h).

The tachometer indicates the approximate number of engine revolutions per minute (rpm).
Use the tachometer to select the correct shift points and to prevent lugging and/or over-revving the engine.
NOTICE
Do not operate the engine within the tachometer's RED ZONE. This may cause severe engine damage.

This gauge shows the temperature of the engine coolant when the ignition switch is in the ON position.
NOTICE
If the gauge pointer moves beyond the normal range area toward the “H or 130” position, it indicates overheating that may damage the engine.
Do not continue driving with an overheated engine. If your vehicle overheats, refer to “If the Engine Overheats” in chapter 6.
WARNING
Never remove the radiator cap and reservoir cap when the engine is hot. The engine coolant is under pressure and could cause severe burns. Wait until the engine is cool before adding coolant to the reservoir.

This gauge indicates the approximate amount of fuel remaining in the fuel tank.
WARNING
Running out of fuel can expose vehicle occupants to danger.
You must stop and obtain additional fuel as soon as possible after the warning light comes on or when the gauge indicator comes close to the “E (Empty) or 0” level.
NOTICE
Avoid driving with a very low fuel level. Running out of fuel could cause the engine to misfire damaging the catalytic converter.

The odometer indicates the total distance that the vehicle has been driven and should be used to determine when periodic maintenance should be performed.

This gauge indicates the current outside air temperatures by 1°C (1°F).
- Temperature range :
- 40°C ~ 85°C (-40°F ~ 211°F)
The outside temperature on the display may not change immediately like a general thermometer to prevent the driver from being inattentive.
To change the temperature unit from °C to °F or °F to °C or
T y p e A
Press the RESET button for more than 5 seconds when the distance to empty is displayed.
T y p e B
Go to User Settings Mode ➝ Other Features ➝ Temperature Unit.

This indicator displays which automatic transaxle shift lever is selected.

This indicator informs which gear is desired while driving to save fuel.
For example
: Indicates that shifting up to
the 3rd
gear is desired (currently the shift
lever is in the 2nd or 1st gear).
: Indicates that shifting down to
the 3rd gear is desired (currently
the shift lever is in the 4th, 5th,
or 6th gear).
When the system is not working properly, the indicator is not displayed.

The pop-up displays the current gear position selected for 2 seconds (P/R/N/D).
Instrument Cluster Control
Warning and indicator lightsLincoln Nautilus 2018-2025 Owners Manual: Using the Valet Mode. Using the Backup Start Passcode
Using the Valet Mode
Press Settings on the touchscreen.
Press Valet Mode.Note: Have your Backup Start Passcode
completely setup before using Valet Mode.
Note: Once the system detects a valid Phone
as a Key, the temporary passcode displays
in both the touchscreen and mobile app. If
the sy ...
Hyundai Creta GS 2014-2025 Service Manual: Repair procedures
Adjustment
Transaxle Control Module
(TCM) Learning
When shift shock is occurred or parts related with the transaxle are replaced,
TCM learning should be performed.
In the following case, TCM learning is required.
•
Transaxle assembly ...