Hyundai Creta: Heater / Heater Core: Repair procedures
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
|
| 3. |
Remove the heater core cover (A) after loosening the mounting screws.
|
| 4. |
Pull out the heater core (A) from the heater unit.
|
| 5. |
Install in the reverse order of removal.
| • |
If you're installing a new heater core, add refrigerant oil
(PAG OIL).
|
| • |
Replace the O-rings with new ones at each fitting, and apply
a thin coat of refrigerant oil before installing them. Be sure
to use the right O-rings for R-134a to avoid leakage.
|
| • |
Immediately after using the oil, replace the cap on the container,
and seal it to avoid moisture absorption.
|
| • |
Do not spill the refrigerant oil on the vehicle; it may damage
the paint; if the refrigerant oil contacts the paint, wash it
off immediately.
|
| • |
Apply sealant to the grommets.
|
| • |
Make sure that there is no air leakage.
|
| • |
Charge the system and test its performance.
|
| • |
Do not interchange the inlet and outlet heater hoses and install
the hose clamps securely.
|
|
Components and components location
Component Location
1. Heater unit assembly
Compoents (1)
1. Heater core cover
2. He ...
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater -"Hea ...
Other information:
Hyundai Creta GS 2014-2019 Service Manual: BJ Boot
Components and components location
Components
1. BJ
assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Dynamic
damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ
boot
10. Spider assembly
11. Retainer ring
...
Hyundai Creta GS 2014-2019 Service Manual: Rear Hub - Carrier
Components and components location
Components
1. Dust cover
2. Rear hub assembly
3. Rear brake disc
Repair procedures
Removal
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure it
is securely s ...
Heater Unit
Evaporator Core: Repair procedures