Hyundai Creta: Lighting System / High Mounted Stop Lamp: Repair procedures

Removal
High Mounted Stop Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear spoiler.
(Refer to Body - "Rear Spoiler")
3.
Remove the high mounted stop lamp assembly (A) after loosening screws (4EA).

4.
Remove the mounted stop lamp connector (A).

Installation
1.
Install the high mounted stop lamp.
2.
Install the rear spoiler.
3.
Connect the negative (-) battery terminal.
License Lamps: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the tailgate trim. (Refer to Body - "Tail Gate Trim") ...

Luggage Room Lamp: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage room lamp assembly (A) after disconnecting the connector. ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Immobilizer Control Unit: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Disconnect the connector of the immobilizer unit and ...

Hyundai Creta GS 2014-2019 Owners Manual: Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty. The spray and wiper operation will continue until you release the lever. If the washer does not work, check ...

В© 2017-2026 www.hcrmangs.com