Hyundai Creta: Braking system / Hill-Start Assist Control (HAC)
A vehicle has the tendency to slide backwards on a steep slope, before depressing the accelerator after a stop. The HAC prevents the vehicle from sliding backwards by automatically operating the brake systems for about 2 seconds. The brake systems are automatically released, when the accelerator pedal is depressed
WARNING
The HAC is activated only for about 2 seconds, so always depress the accelerator pedal to begin driving upwards after a stop.
Information
- The HAC does not operate when the shift lever is in P (Park) or N (Neutral)
- The HAC activates even when the ESC (Electronic Stability Control) is off. However, it does not activate, when the ESC does not normally operate.
Vehicle Stability Management
Vehicle Stability Management (VSM)
helps ensure the vehicle stays stable
when accelerating or braking suddenly
on wet, slippery and rough
roads where traction over the four
tires can suddenl ...
Good braking practices
WARNING
Whenever leaving the vehicle or
parking, always come to a complete
stop and continue to depress
the brake pedal. Move the shift
lever into the 1st gear (for manual
transaxle vehicle ...
Other information:
Hyundai Creta GS 2014-2024 Service Manual: Crankshaft Position Sensor (CKPS)
Description and operation
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one
of the most important sensors of the engine control system. If there is no CKPS
signal input, fuel is not supplied.That is, vehicle can't run without CKPS sig ...
Hyundai Creta GS 2014-2024 Service Manual: Components and components location
Components
Connector Pin Information
No
Connector A
Connector B
Connector C
1
Left static bending relay_output
-
Front wiper intermittent volume_input
2
...
