Hyundai Creta: Immobilizer System / Immobilizer Control Unit: Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Disconnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening a nut and a bolt.

Installation
1.
Install the immobilizer control unit after connecting the unit connector.
2.
Install the crash pad lower panel.
Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM (ECM) or when providing additional keys to the vehi ...

Antenna Coil: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column shroud panel. (Refer to Body - "Crash P ...

Other information:

Hyundai Creta GS 2014-2022 Service Manual: Wheel: Repair procedures
Inspection Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque (Front) : 88.25 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) Tightening torque (Rear) : 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Hyundai Creta GS 2014-2022 Service Manual: Parking Assist Sensor
Components and components location Component Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") ...

© 2017-2022 www.hcrmangs.com