Hyundai Creta: Lubrication System / Oil Pressure Switch: Repair procedures

Removal and Installation

1.	Disconnect the battery negative terminal.

2.	Remove the engine room under cover. (Refer to Engine And Transaxle Assmbly - "Engine Room Under Cover" )

3.	Drain the engine oil. (Refer to Lubrication System - "Engine Oil")

4.	Disconnect the oil pressure switch connector (A).

Remove the oil pressure switch (B).

Tightening torque :

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

6.	Install in the reverse order of removal.

•	When installing the oil pressure switch, apply seal lock to the thread.

Seal lock : THREE BOND 2403

Thickness : 0.2 ~ 0.4 mm (0.008 ~ 0.016 in)

Inspection

1.	Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch.

2.	Check the continuity between the terminal and the body when the fine wire is pushed. If there is continuity even when the fine wire is pushed, replace the switch.

3.	If there is no continuity when a 49.0kpa (0.5kg/cm², 7.1psi) vacuum is applied through the oil hole, the switch is operating properly. Check for air leakage. If air leaks, the diaphragm is broken. Replace it.

Components and components location Components 1. Timing chain cover 2. Inner rotor 3. Outer rotor 4. Pump cover R ...

Components and components location Components 1. Gasket 2. Oil screen 3. Oil pan 4. Drain plug gasket 5. Drain plug Repair procedures ...

Hyundai Creta GS 2014-2019 Service Manual: Components and components location
Components 1. Front bumper cover 2. Front bumper side bracket [LH] 3. Front bumper side bracket [RH] ...

Hyundai Creta GS 2014-2019 Service Manual: Components and components location
Component Location 1. Hood switch 2. Burglar horn 3. Body Control Module (BCM) 4. Door lock / unlock buzzer 5. Front door lock actuator & switch 6. Rear door lock actuator & switch 7. Tailgate open switch ...