Hyundai Creta: Lighting System / Overhead Console Lamp: Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
If necessary to replace the bulb only, replace the bulb after opening the overhead console lens (A).

3.
Remove the overhead console (A) after loosening the screws.

4.
Disconnect the connectors (A) of lamp switch then remove the overhead console lamp assembly.

Installation
1.
Install the overhead console lamp after connecting the lamp connector.
2.
Install the overhead console lamp assembly after tightening screws.
Inspection
1.
Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.

No
Description
1
Ground (-)
2
Battery (+)
3
Door (-)
4
Room lamp signal (-)

Room Lamp: Repair procedures
Inspection Room Lamp 1. Check that the switch operates properly after disconnecting the room lamp connector (A). ...

Turn Signal Lamp: Repair procedures
Removal Door Mirror Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror holder (A) from the outside ...

Other information:

Hyundai Creta GS 2014-2026 Service Manual: Parking Assist Sensor
Components and components location Component Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") ...

Lincoln Nautilus 2018-2026 Owners Manual: Steering
Electric Power Steering Electric Power Steering Precautions WARNING: The electric power steering system has diagnostic checks that continuously monitor the system. If a fault is detected, a message displays in the information display. Stop your vehicle as soon as it is safe to do so. Switch the ...

В© 2017-2026 www.hcrmangs.com