Hyundai Creta: Rear Parking Assist System / Parking Assist Sensor

Components and components location

Component

Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
3.
Disconnect the connector (B) from the parking assist sensor (A).

4.
Pull out the sensor (A) by opening the sensor holder (B) out.

Installation
1.
Install the rear ultra sensor after connecting the connector.
2.
Install the rear bumper cover.
3.
Connect the negative (-) battery terminal.
Description and operation
System Overview RPAS(Rear Parking Assist System) is an electronic driving aid device warning driver to be cautious when they park or speed low after detecting an object on side a ...

Back View Camera System
...

Other information:

Hyundai Creta GS 2014-2025 Service Manual: General safety information and caution
Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbags could accidentally deploy and cause damage or injuries. • ...

Hyundai Creta GS 2014-2025 Owners Manual: Fuses
A vehicle’s electrical system is protected from electrical overload damage by fuses. This vehicle has 2 fuse panels, one located in the driver’s side panel bolster, the other in the engine compartment near the battery. If any of your vehicle’s lights, accessories, or controls d ...

© 2017-2025 www.hcrmangs.com