Hyundai Creta: Seat Electrical / Power Seat Motor: Repair procedures

Inspection
Power Seat Motor
1.
Disconnect the connectors for each motor.
(Refer to Body - "Front Seat Assembly")
A : Slide motor
B : Rear height motor
C : Front height motor
D : Recline motor

2.
With the battery connected directly to the motor terminals, check if the motors run smoothly.
3.
Reverse the connections and check that the motor turns in reverse.
4.
If there is an abnormality, replace the motors.

Reclining Motor Limit Switch
1.
Disconnect the limit switch and operate the limit switch.
2.
Check for continuity between the terminals.
3.
Make sure that the seat operation is normal in the reverse after the maximum operation.
4.
If there is an abnormality, replace the limit switch.

Components and components location
Component Location 1. Reclining motor 2. Slide motor 3. Rear height motor 4. Front tilt motor 5. Seat back switch (reclining) 6. Seat cushion (sliding/h ...

Power Seat Control Switch
Schematic diagrams Circuit Diagram Repair procedures Inspection 1. With the power seat switch in each position, make sure that continuity exists ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Power Door Mirror Actuator
Components and components location Components Repair procedures Inspection 1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (B) after removing the front door quadrant cover (A). ...

Hyundai Creta GS 2014-2019 Service Manual: Clutch Release Fork and Clutch Release Bearing
Components and components location Components 1. Clutch release fork 2. Clutch cover assembly 3. Clutch disk assembly 4. Clutch release bearing Repair procedures Removal 1. Remove the manual transaxle assembly. ...

В© 2017-2026 www.hcrmangs.com