Hyundai Creta: Rear Suspension System / Rear Coil Spring

Components and components location

Components

1. Spring lower pad
2. Spring

3. Spring upper pad

Removal

1.	Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.

Remove the rear wheel and tire (A).

Tightening torque :

88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

•	Be careful not to damage the hub bolts when removing the rear wheel and tire.

Loosen the bolt and then remove the rear shock absorber (A) from the torsion beam axle. [Both side]

Tightening torque :

98.1 ~ 117.7 N.m (10.0 ~ 12.0 kgf.m, 72.3 ~ 86.8 lb-ft)

4.	Pull the torsion beam axle in the direction of a down and then remove the coil spring (A).

5.	Install in the reverse order of removal.

Inspection

1.	Check the coil spring for crack and deformation.

2.	Check the coil spring pad for damage and deformation.

Components and components location Components 1. Shock absorber 2. Dust cover 3. Bumper rubber 4. Insulator assembly 5. Washer 6. Lock nut 7. Ins ...

Components and components location Components 1. Rear torsion beam axle Repair procedures Removal 1. Loosen the wheel ...

Hyundai Creta GS 2014-2025 Service Manual: Hood Weatherstrip: Repair procedures
Replacement 1. Remove the hood weatherstrip (A). • Be careful not to scratch the hood weatherstrip. ...

Hyundai Creta GS 2014-2025 Service Manual: Coolant: Repair procedures
Replacement And Air Bleeding • Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure escaping from the ra ...