Removal |
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Loose the screws (2EA) holding the rear combination lamp then disconnect
the connector (A) then remove the outside rear combination lamp (B).
|
3. |
If it is necessary to replace the bulb, remove the rear combination
cover (A).
|
4. |
Disconnect the rear combination lamp connecter (C).
|
5. |
Remove the Back up lamp (A).
|
6. |
Remove the Tail lamp (B).
|
7. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
|
8. |
Remove the inside rear combination lamp assembly (A) after loosening
the nuts (4EA) and disconnecting the connector.
|
9. |
Remove the Turn signal lamp bulb (A).
|
10. |
Remove the stop lamp bulb (B).
|
11. |
If it is necessary to replace the bulb, remove the bulb after removing
the tailgate cover.
|
Installation |
1. |
Install the tailgate combination lamp assembly after assembling the
bulb.
|
2. |
Install the lamp cover to the tailgate after connecting the lamp connector.
|
3. |
Install the rear combination lamp assembly after assembling the bulbs
and connecting the lamp connector.
|
Hyundai Creta GS 2014-2022 Service Manual: Components and components location
Component Location
1. Reclining motor
2. Slide motor
3. Rear height motor
4. Front tilt motor
5. Seat back switch (reclining)
6. Seat cushion (sliding/height/tilt)
...
Hyundai Creta GS 2014-2022 Owners Manual: Digital clock
WARNING
Do not adjust the clock while driving.
You may lose your steering
control and cause severe personal
injury or accidents.
Whenever the battery terminals or
related fuses are disconnected, you
must reset the time.
When the ignition switch is in the
ACC or ON position, the cloc ...