Hyundai Creta: Body Side Molding / Rear Mud Guard: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Body (Interior and Exterior) / Body Side Molding / Rear Mud Guard: Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

1.	After loosening the mounting clip and screws, then remove the rear mud guard (A).

To install, reverse the removal procedure.

•	Replace any damaged clips.

Front Mud Guard: Repair procedures

Replacement • Put on gloves to protect your hands. ...

Side Sill Molding: Repair procedures

Replacement • Put on gloves to protect your hands. ...

Other information:

Hyundai Creta GS 2014-2019 Owners Manual: Checking the brake/clutch fluid level
Check the fluid level in the reservoir periodically. The fluid level should be between MAX (Maximum) and MIN (Minimum) marks on the side of the reservoir. Before removing the reservoir cap and adding brake/clutch fluid, clean the area around the reservoir cap thoroughly to prevent b ...

Hyundai Creta GS 2014-2019 Service Manual: Troubleshooting
Troubleshooting Symptom Possible cause Remedy Hard steering Improper front wheel alignment Excessive turning resistance of lower arm ball joint Low tire pressure No power assist Correct Replace ...