Hyundai Creta: Body Side Molding / Rear Wheel Guard: Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

1.	Remove the rear tire.

2.	After loosening the mounting clips and nut, then remove the rear wheel guard (A).

To install, reverse the removal procedure.

•	Replace any damaged clips.

Replacement • Put on gloves to protect your hands. ...

Replacement • Put on gloves to protect your hands. ...

Hyundai Creta GS 2014-2019 Service Manual: Line Pressure Control Solenoid Valve
Description and operation Description • Line pressure control solenoid valve is attached to the valve body. • This variable force solenoid valve indirectly controls the hydraulic pressure inside the line pressure. ...

Hyundai Creta GS 2014-2019 Service Manual: Variable Intake Solenoid(VIS) Actuator: Repair procedures
Removal and Installation 1. Disconnect the battery negative terminal. 2. Remove the air cleaner assembly. (Refer to Intake and Exhaust System - "Air Cleaner") 3. Disconnect the lever (A) a ...