Hyundai Creta: Air Conditioning System / Receiver-Drier: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Receiver-Drier: Repair procedures

Replacement

1.	Remove the condenser.

Remove the cap (B) on the bottom of the condenser with a L wrench (A).

Tightening torque :

9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)

3.	Remove the receiver-drier (A) from condenser using a long nose plier. Check for crumbled receiver-drier and clogged bottom cap filter.

4.	Apply air conditioning compressor oil along the O-rings and threads of the new bottom cap.

5.	Insert a new receiver-drier into the receiver drier tank. The receiver-drier must be sealed in vacuum before it is exposed to air for use.

Install a new bottom cap to the condenser.

•	Always replace the receiver-drier and bottom cap at the same time.

•	Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.

•	Be careful not to damage the radiator and condenser fins when installing the condenser.

•	Charge the system, and test its performance.

Condenser

Components and components location Components Location 1. Condenser Repair procedures Inspection 1. Check the condens ...

A/C Pressure Transducer

Components and components location Components Location 1. A/C Pressure Transducer Description and operation Description The A/C Press ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Climate Control Air Filter
Description and operation Description The climate control air filter is located in the blower unit. It eliminates foreign materials and odor. The particle filter performs a role as an odor filter as well as a conventional dust filter to ensure comfortable interior environment ...

Hyundai Creta GS 2014-2019 Service Manual: Starter Relay: Repair procedures
Inspection 1. Disconnect the battery negative terminal. 2. Remove the fuse box cover. 3. Remove the starter relay (A). 4. Using an ohmmeter, check that there is continuity b ...