Inspection |
1. |
After disconnecting the vapor hose from the PCV valve, remove the PCV
valve.
|
2. |
Reconnect the PCV valve to the vapor hose.
|
3. |
Run the engine at idle, then put a finger over the open end of the PCV
valve and make sure that intake manifold vacuum can be felt.
|
4. |
If the vacuum is not felt inspect PCV operation, if operating correctly
clean or replace the vapor hose.
|
Hyundai Creta GS 2014-2024 Service Manual: Rear Washer Switch: Repair procedures
Inspection
Multifunction Switch Inspection
1.
Check for continuity between the terminals in each switch position according
to the table.
[Left Handle Drive]
Switch
Switch position
...
Hyundai Creta GS 2014-2024 Service Manual: Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting and test
procedure as follows. Compare the system condition with normal condition in
the table below and if abnormal symptom is detected, perform necessary remedy
and inspection.
...