Hyundai Creta: Injector / Repair procedures
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect injector connector.
|
| 3. |
Measure resistance between injector terminals 1 and 2.
|
| 4. |
Check that the resistance is within the specification.
|
Specification : Refer to "Specification"
|
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
terminal.
|
| 2. |
Release the residual pressure in fuel line.
(Refer the fuel Delivery system - Repair Procedures - "Release Residual
Pressure in Fuel Line")
| •
|
When removing the fuel pump fuse, a Diagnostic Trouble
Code (DTC) may occur. Delete the code with the GDS after
completion of "Release Residual Pressure in Fuel Line"
work.
|
|
|
| 3. |
Disconnect the injector connector (A).
|
| 4. |
Remove the wiring harness bracket mounting bolt (B).
|
| 5. |
Remove the mounting nut, and then disconnect the fuel feed tube (C).
|
| 6. |
Remove the mounting bolt, and then remove the delivery pipe & injector
assembly from the engine.
|
| 7. |
Remove the fixing clip (A), and then separate the injector from the
delivery pipe.
|
| • |
Install the component with the specified torques.
|
| • |
Note that internal damage may occur when the component is dropped.
In this case, use it after inspecting
|
|
| • |
Apply the engine oil to the injector O-ring.
|
|
| • |
Inspect the injector O-ring when installing.
|
|
| 1. |
Install in the reverse order of removal.
|
Delivery pipe mounting bolt :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Delivery pipe mounting nut (↔ Fuel feed tube) :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
|
|
Circuit Diagram
(M/T)
(A/T)
...
Description and operation
Description
Purge Control Solenoid Valve (PCSV) is a solenoid valve and is installed on
the surge tank and controls the passage between the canister and t ...
Other information:
Hyundai Creta GS 2014-2019 Owners Manual: Light bulbs
Consult an authorized HYUNDAI
dealer to replace most vehicle light
bulbs. It is difficult to replace vehicle
light bulbs because other parts of the
vehicle must be removed before you
can get to the bulb. This is especially
true for removing the headlight
assembly to get to the bulb(s). ...
Hyundai Creta GS 2014-2019 Service Manual: ETC (Electronic Throttle control) System
Description and operation
Description
The Electronic Throttle Control (ETC) System consists of a throttle body with
an integrated control motor and throttle position sensor (TPS). Instead of the
traditional throttle cable, an Accelerator Position Sensor (APS) is used to
rec ...
Schematic diagrams
Purge Control Solenoid Valve (PCSV)