Hyundai Creta: Automatic Transaxle Control System / Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Repair procedures

Adjustment

Transaxle Control Module (TCM) Learning

When shift shock is occurred or parts related with the transaxle are replaced, TCM learning should be performed.

In the following case, TCM learning is required.

•	Transaxle assembly replacement

•	TCM replacement

•	TCM upgrading

TCM learning procedure

1.	Automatic Transaxle Fluid (ATF) temperature: 40 ~ 100°C (104 ~ 212°F)

2.	Static learning Repeat the below shift pattern four times or more with stepping on the brake.

3.	Driving learning Drive the vehicle from a stop in D through all gears 1st, 2nd, 3rd, 4th, 5th and 6th gear while holding the throttle steady at the specified Throttle Position Sensor (TPS) value (15 ~ 25%).

Schematic diagrams

Circuit Diagram ...

Transaxle Control Module (TCM)

Description and operation Description • Monitoring the vehicle's operating conditions to determine the optimal gear setting. • ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Overhead Console Lamp: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. If necessary to replace the bulb only, replace the bulb after opening the overhead console lens (A). 3. Remove the overhead console (A) a ...

Hyundai Creta GS 2014-2019 Service Manual: Shift Lever
Components and components location Components 1. Shift lever knob & boots 2. Shift lever assembly 3. Shift cable 4. Select cable 5. Retainer 6. 4th fixed pin Repair procedures Removal 1. Remove the shif ...