Hyundai Creta: General Information / Repair procedures
| Component Replacement After Deployment |
|
When the front airbag(s) deployed after a collision, replace the following items.
| – |
SRSCM
|
| – |
Deployed airbag(s)
|
| – |
Seat belt pretensioner(s)
|
| – |
Front impact sensors
|
| – |
SRS wiring harnesses
|
| – |
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
|
When the side/curtain airbag(s) deployed after a collision, replace the following
items.
| – |
SRSCM
|
| – |
Deployed airbag(s)
|
| – |
Side impact sensor(s) for the deployed side(s)
|
| – |
SRS wiring harnesses
|
| – |
Seat belt pretensioner(s)
|
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
| – |
Turn the ignition switch ON; the SRS indicator should come on for about
six seconds and then go off.
|
Description and operation
Warning Lamp Activation
Warning Lamp Behavior
after Ignition On
As soon as the operating voltage is applied to the SRSCM ignition input, the
SRSCM activates the wa ...
Components and components location
Components Location
Supplemental Restraint
System Control Module (SRSCM)
1. Supplemental Restraint
System Control Module (SRSCM)
...
Other information:
Hyundai Creta GS 2014-2024 Owners Manual: Temperature control
The temperature will increase by
turning the knob to the right.
The temperature will decrease by
turning the knob to the left.
Air intake control
This button is used to select the outside
(fresh) air position or recirculated
air position.
Recirculated air position
With the recircu ...
Hyundai Creta GS 2014-2024 Service Manual: Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting and test
procedure as follows. Compare the system condition with normal condition in
the table below and if abnormal symptom is detected, perform necessary remedy
and inspection.
...
© 2017-2024 www.hcrmangs.com
