Hyundai Creta: Fender / Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Body (Interior and Exterior) / Fender / Repair procedures

Replacement

•	Be careful not to damage the fender and body.

•	When removing the clips, use a clip remover.

1.	Remove the front bumper. (Refer to Front Bumper - "Front Bumper Cover")

2.	Remove the head lamps. (Refer to Body Electrical System - "Head Lamps")

3.	Remove the front wheel guard. (Refer to Body Side Molding - "Front Wheel Guard")

4.	Remove the fender garnish. (Refer to Body Side Molding - "Fender Garnish")

5.	Remove the side sill molding. (Refer to Body Side Molding - "Side Sill Molding")

6.	Remove the front bumper side mounthing bracket (A) after loosening the screw and bolt.

7.	Remove the fender assembly (A) after loosening the bolts.

To install, reverse the removal procedure.

•	Replace any damaged clips.

Components and components location

Component Location 1. Fender assembly ...

Hood

...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: General information
General Service Information Protection of the Vehicle Always be sure to cover fenders, seats, and floor areas prior to beginning work. The support rod must be inserted into the hole near the edge of the ...

Hyundai Creta GS 2014-2019 Service Manual: Immobilizer Control Unit: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Disconnect the connector of the immobilizer unit and ...