Hyundai Creta: Horn / Repair procedures

Removal
1.
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
2.
After loosening each mounting bolt of the high-pitch horn (A) and low-pitch horn (B), detach the connector (C) and remove the horn.

Installation
1.
Install the horns after connecting the horn connectors.
2.
Install the front bumper cover.
Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace it.
Horn Relay Inspection
Horn relay is installed on the PCB fuse & relay block in the engine room block.
This PCB relay is needed to replace with the PCB fuse & relay block assembly only.
Components and components location
Component Location 1. Horn switch 2. Horn relay (Engine room - PCB Fuse & Relay Block) 3. Horn (Low pitch) 4. Horn (High pitch) 5. Clock spring ...

Multifunction Switch
...

Other information:

Hyundai Creta GS 2014-2025 Service Manual: Fog Lamps: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper. (Refer to Body - "Front Bumper Cover") 3. Remove the front fog lamp assembly (A) after loosening the mounti ...

Hyundai Creta GS 2014-2025 Service Manual: Front Door Belt Outside Weatherstrip: Repair procedures
Replacement 1. Pull down front door window glass by pressing the power window glass switch. 2. Remove the front door belt outside weatherstrip (A). 3. To install, reverse the removal procedure. ...

© 2017-2025 www.hcrmangs.com