Inspection |
1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
2. |
Remove the front door module.
(Refer to Body - "Front Door Module")
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check actuator operation by connecting power and ground according to
the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
2. |
Remove the rear latch.
(Refer to Body - "Rear Door Latch")
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check actuator operation by connecting power and ground according to
the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
|
2. |
Disconnect the 4P connector from the actuator.
|
3. |
Check actuator operation by connecting power and ground according to
the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
|
2. |
Disconnect the switch connector.
|
3. |
Check for continuity between the terminals in each switch position according
to the table.
|
1. |
Disconnect the connector (A) and bolts from the hood switch.
|
2. |
Check for continuity between the terminals and ground according to the
table.
|
1. |
Remove the burglar horn (A) after removing a bolt and disconnect the
2P connector from the burglar horn.
|
2. |
Test the burglar horn by connecting battery power to the terminal 1
and ground the terminal 2.
|
3. |
The burglar horn should sound. If the burglar horn fails to sound replace
it.
|
Hyundai Creta GS 2014-2024 Service Manual: Description and operation
Warning Lamp Activation
Warning Lamp Behavior
after Ignition On
As soon as the operating voltage is applied to the SRSCM ignition input, the
SRSCM activates the warning lamp for a LED lamp check.
The lamp shall turn on for 6 seconds during the initialization ...
Hyundai Creta GS 2014-2024 Service Manual: Underdrive Brake Control Solenoid Valve (UD/B_VFS)
Description and operation
Description
•
Underdrive brake control solenoid valve (UD/B) is attached to the valve
body.
•
This variable force solenoid valve indirectly controls the hydraulic
pressure inside the underdrive b ...