Hyundai Creta: Electro Chromic Inside Rear View Mirror / Repair procedures

Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the "ON" position.
2.
Cover the forward facing sensor.
3.
Head a light to the rearward looking sensor.
4.
The ECM should be darkened as soon as the rearward looking sensor detects the light.
  
•
If this test is performed in daytime, the ECM may be darkened as soon as the forward facing sensor is covered.
5.
When the reverse gear is engaged, the ECM should not be darkened.
When heading lights to both the forward facing and rearward looking sensors, the ECM should not be darkened.
Removal
1.
Remove the mirror wiring cover (A).

2.
Remove the mirror mounting screw (A) and connector (B).

3.
Remove the mirror (A) pulling up in the arrow direction.
  
•
Make sure not to damage the mounting bracket when removing the mirror.

Installation
1.
Install the mirror making sure the mounting bracket not to be damaged.
2.
Install the mirror wiring cover after reconnecting the connector and tightening the screw.
Description and operation
Description The ECM (Electro Chromatic inside rear view Mirror) is intended dim the reflecting light in the rear view mirror. The forward facing sensor detects brightness of the ...

Rear Parking Assist System
...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Rear Door Side Weatherstrip: Repair procedures
Replacement 1. Loosen the rear door checker (B) mounting bolt. Tightening torque : 21.6 ~ 32.3 N.m (2.2 ~ 3.2 kgf.m,16.9 ~ 23.9 lb-ft) 2. Detach the clips, then remove the rear door si ...

Hyundai Creta GS 2014-2019 Service Manual: ETC (Electronic Throttle control) System
Description and operation Description The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cable, an Accelerator Position Sensor (APS) is used to rec ...

© 2017-2026 www.hcrmangs.com