Hyundai Creta: Body Side Molding / Roof Side Molding: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding: Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

Using a screwdriver or remover, remove the roof side molding (A).

•	Relplace the roof side molding to a new one.

To install, reverse the removal procedure.

•	Replace any damaged clips.

Roof Rack: Repair procedures

Replacement • Put on gloves to protect your hands. ...

A Pillar Garnish: Repair procedures

Replacement • Put on gloves to protect your hands. ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Steering Angle Sensor: Description and operation
Description Steering angle sensor The Steering Angle Sensor (SAS) is installed in EPS (Electric Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning direction and speed of the steering wheel. The HECU uses t ...

Hyundai Creta GS 2014-2019 Service Manual: Repair procedures
Removal 1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so that the front wheels are placed in the straight ahead position. 3. ...