Hyundai Creta: Starting System / Starter Relay: Repair procedures
Hyundai Creta GS 2014-2019 Service Manual / Engine Electrical System / Starting System / Starter Relay: Repair procedures
| Inspection |
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Remove the fuse box cover.
|
| 3. |
Remove the starter relay (A).
|
| 4. |
Using an ohmmeter, check that there is continuity between each terminal.
|
| 5. |
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.
|
| 6. |
If there is no continuity, replace the starter relay.
|
| 7. |
Install the starter relay.
|
| 8. |
Install the fuse box cover.
|
Starter
Description and operation
Description
The starting system includes the battery, starter, solenoid switch, ignition
switch, inhibitor switch (A/T), clutch pedal switch (M/T), igniti ...
Other information:
Hyundai Creta GS 2014-2019 Service Manual: Front Door Outside Handle
Components and components location
Component Location
1. Front door outside handle
Repair procedures
Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
...
Hyundai Creta GS 2014-2019 Service Manual: Wheel: Repair procedures
Inspection
Hub nut tightening sequence
Tighten the hub nuts as follows.
Tightening torque (Front) :
88.25 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Tightening torque (Rear) :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...
В© 2017-2026 www.hcrmangs.com
