To equalize tread wear, it is recommended that the tires be rotated every 12,000 km (7,500 miles) or sooner if irregular wear develops.
During rotation, check the tires for correct balance.
When rotating tires, check for uneven wear and damage. Abnormal wear is usually caused by incorrect tire pressure, improper wheel alignment, outof- balance wheels, severe braking or severe cornering. Look for bumps or bulges in the tread or side of tire. Replace the tire if you find either of these conditions. Replace the tire if fabric or cord is visible. After rotation, be sure to bring the front and rear tire pressures to specification and check lug nut tightness.
Refer to “Tire and wheels� in chapter 8.

Disc brake pads should be inspected for wear whenever tires are rotated.
Information
Rotate radial tires that have an asymmetric tread pattern only from front to rear and not from right to left.
WARNING
Checking tire inflation pressure
Wheel alignment and tire balanceHyundai Creta GS 2014-2019 Owners Manual: Key ignition switch
WARNING
NEVER turn the ignition switch
to the LOCK or ACC position
while the vehicle is in motion
except in an emergency. This
will result in the engine turning
off and loss of power assist for
the steering and brake systems.
This may lead to loss of directional
control ...
Hyundai Creta GS 2014-2019 Service Manual: Components and components location
Component Location
1. Horn switch
2. Horn relay (Engine room - PCB Fuse & Relay Block)
3. Horn (Low pitch)
4. Horn (High pitch)
5. Clock spring
...